WHETHER you're using lasers for surgery or semiconductor etching, controlling the temperature of the target material--without touching the surfaces involved--can be critical. In laser tissue welding, laser energy activates tissue bonds between the surgical surfaces, fusing them together. If there's too much heat, the tissue is damaged, and poor healing results. If there's not enough heat, the bonds don't form. For semiconductors, too much heat during the dry etching process can glue or "crosslink" the thin photoresist layer to the silicon wafer.|
An award-winning, Two-Color Fiber-Optic Infrared Sensor developed by Ward Small IV and others in Livermore's Medical Technology Program (Figure 1, above) not only measures temperatures in this critical temperature regime, but also measures the emissivity, a number between zero and one that indicates how well a target emits infrared radiation, that is, heat. (For example, highly reflective surfaces are generally poor emitters and thus have emissivities close to zero. A piece of black-painted metal, on the other hand, has an emissivity close to one.)
"This low-temperature regime--50 to 80°C--is of particular interest in the medical field, where lasers are becoming the tool of choice for therapeutic and minimally invasive surgical procedures," says Small.
Most commercial infrared sensors measure surface temperatures of hundreds or thousands of degrees Celsius. The difficulty with measuring surfaces near room temperature is that such surfaces emit infrared signals that are weak and don't easily transmit because of their longer wavelength. The few sensors that do measure in this temperature regime assume an emissivity of 1 or a lack of sufficient spatial resolution. "Ours is the only low-temperature, noninvasive sensor with high spatial resolution that measures both temperature and emissivity," notes Small.
Measuring both variables significantly reduces the error that creeps in when measurements are taken in only one infrared wavelength band, or color. This error can be as high as 40% for materials that have a moderately reflective surface.
How It Works
The Acid Test|
An in vivo feasibility test of this sensor conducted at the Harbor Medical Center of the University of California at Los Angeles (UCLA) using an animal subject (Figure 3) showed that the feedback from this temperature sensor system helps to optimize and improve the consistency of the final laser weld. In the test, an expert laser surgeon performed tissue welds with the sensor and without the sensor. The finished welds were then tested for burst strength. Of the two, the weld created with the sensor feedback loop proved the stronger.
The team also performed simulations of this experiment to show that welds without the benefit of temperature control have higher, potentially more damaging, internal temperatures. This simulation shows surgeons that even though they watch the surface for clues that the temperature is too high, the tissue heats up more underneath the surface. Overheating can lead to poor healing and can kill the tissue.
For the Future|
The process has a broad range of surgical applications, including vessel grafts and repair, skin wound closure, and nerve repair. For any target that has unknown or variable emissivity, the sensor provides fast, noninvasive, high-resolution temperature measurements.
The Laboratory is now collaborating with Conversion Energy Enterprises as well as the University of California campuses at San Francisco and Davis to research the use of this temperature-controlled laser technique to repair congenital aorta defects in infants. Initial results show that blood leakage can be reduced by as much as 70% when this technique is used with conventional sutures.
Key Words: infrared sensor, laser surgery, optical fiber, semiconductors, Two-Color Fiber-Optic Infrared Sensor.
For further information contact Peter Celliers (925) 424-4531 (email@example.com).